Skip to main content

Open 24/7 for no heat, leaks and backups

Dr. Boilerby Encano

Hydronic heating, Richmond · open 24/7

Boiler Repair in Richmond, BC Warm radiators again, often the same day

No heat, low pressure or a leaking boiler? Call or text our family-run team 24/7. Free assessment in Richmond and a flat-rate price before any work starts.

  • 5.0 on Google, 56 reviews
  • No-heat calls 24/7
  • 1-year workmanship warranty
Gas-fired hydronic boiler with expansion tank and copper piping, serviced by Encano
Encano boiler job (from our Google profile)

What should I do if my boiler stops heating in Richmond?

Check the thermostat setting, the boiler’s power switch and the pressure gauge (most home systems run around 12 to 15 psi cold). If the pressure is low, the radiators stay cold or the boiler shows a lockout, call a technician. Encano Plumbing takes no-heat boiler calls in Richmond 24/7 and quotes a flat-rate price before starting the repair.

A boiler heats water and pushes it through pipes to radiators, baseboards or tubing under the floor. When one part of that loop fails, the whole home goes cold, usually on the first chilly night of October. In Richmond, that system often sits in a townhouse closet or a garage corner, serving two or three zones.

Encano Plumbing is a family-owned plumbing and heating company based in Richmond. Our team diagnoses the actual cause first: pressure, air in the lines, a seized circulator, a stuck zone valve or an ignition fault. Then you get a written, flat-rate price, and no work starts until you say yes.

We repair boilers in detached houses and in strata townhouses, and give strata councils a clear written quote they can approve.

Signs your Richmond boiler needs a repair

  • No heat at all

    The boiler is silent or runs but the house stays cold. Often an ignition, thermostat, pump or power issue.

  • Pressure keeps dropping

    The gauge falls below normal and you keep topping it up. That points to a leak, a failing relief valve or an expansion tank problem.

  • Kettling, banging or gurgling

    Rumbling like a kettle can mean scale or poor flow through the heat exchanger. Gurgling usually means trapped air.

  • Water on the floor

    Drips under the boiler, at a radiator valve or near the relief valve discharge pipe should be looked at before they damage flooring or drywall.

  • Pilot or ignition lockout

    The boiler tries to fire, fails and shows a fault code or a reset light. Repeated resets are a sign to stop and call.

  • Cold radiators or cold zones

    Some rooms heat and others stay cold, or radiators are warm at the bottom and cold at the top. Air, a stuck zone valve or a weak circulator are common causes.

What our boiler service in Richmond covers

Every visit starts with a full check of the heating loop, not only the box on the wall. Here is what we look at and repair.

Diagnosis and fault codes
We read the control’s fault history, test the thermostat call, ignition sequence and safety switches, and find the actual cause before quoting.
Pressure, expansion tank and relief valve
We check system fill pressure, the expansion tank charge and the pressure relief valve. A waterlogged tank often causes pressure swings.
Circulator pumps and air removal
We test circulator pumps for flow and noise, replace seized or failing ones, and purge air from radiators, baseboards and radiant floor loops.
Zone valves and controls
Multi-zone systems in townhouses and larger homes rely on zone valves or zone pumps. We test each zone, repair sticking valves and fix wiring or thermostat faults.
Venting and combustion safety
We inspect the venting and air supply, check the burner and combustion, and test for carbon monoxide around the appliance. If anything is unsafe, we tell you plainly and shut it down.
Annual boiler maintenance
A yearly service before the cold: cleaning, safety check, pressure and tank check, pump and valve test, and a note on worn parts.

How a boiler repair call works

  1. 01

    Call or text

    Reach us at (604) 764-2031, day or night. Tell us what the boiler is doing, any fault code and whether you have heat in any room.

  2. 02

    On-site diagnosis

    We test the boiler and the whole loop, find the cause and explain it in plain words, including whether a repair makes sense on an older unit.

  3. 03

    Flat-rate price, then repair

    You get the price in writing before any work starts. Once you approve, we make the repair, refill and purge the system, and confirm every zone heats.

  4. 04

    Test, clean up and warranty

    We run the boiler through a full cycle, check pressure and combustion, clean the work area and back the job with our 1-year workmanship warranty.

How much does boiler repair cost in Richmond?

We do not post a price list, because the price depends on the service, the time and day you need us, and whether it is an emergency. You get one flat price in writing before any work starts.

What you pay forHow it is priced
Boiler repairDepends on the part (pump, valve, igniter, control board), the boiler age and access.Quoted in writing before work starts
Annual boiler maintenanceCleaning, pressure and safety checks before the heating season.Quoted in writing before work starts
Nights, weekends and emergenciesWe confirm the price for an after-hours call before we come out.Quoted in writing before work starts

Your price depends on the service, the time and day, and whether it is an emergency. You see the exact price in writing and agree to it before anyone touches a tool.

The assessment is free in Richmond. Outside Richmond, travel time is charged, and we quote it before we come out. If you go ahead with the work, you get a discount on that travel time. You always know the price before we go.

Boiler repair across Richmond, from Steveston to City Centre

Hydronic heat is common in Richmond townhouses and strata complexes, and in many newer houses with radiant floors. These systems are quiet and comfortable, but they live in tight closets and garages, and one failed pump or zone valve can leave a whole unit cold. We are based in Richmond, so a no-heat call in Terra Nova, Broadmoor or Garden City does not mean a long drive across the region.

Richmond sits on Lulu Island, close to sea level, with damp, mild winters. Mechanical rooms in garages and crawl-space-level closets stay humid, which speeds up corrosion on fittings, relief valves and expansion tanks. We check those parts on every visit. For strata buildings, we work with owners and property managers so repairs on shared systems are documented and approved before work starts.

Neighborhoods we work in

  • Steveston
  • Terra Nova
  • Broadmoor
  • Seafair
  • Thompson
  • Blundell
  • Garden City
  • Ironwood
  • East Richmond
  • City Centre
  • Brighouse
  • Westwind

Get your boiler serviced before the heating season

In Metro Vancouver the heating season runs roughly October to April. Most no-heat boiler calls come on the first cold nights of fall, when a system that sat idle all summer is asked to run again. Pumps that seized, air that collected in the lines and expansion tanks that lost their charge all show up at once.

An annual service in September or early October catches most of that before you need the heat. If your heat fails during a cold snap, call us any time, day or night.

Gas appliance work is done to BC code by a licensed gas fitter, with a permit pulled when the job requires one. If you smell gas, leave the home and call FortisBC at 1-800-663-9911 and 911 from outside.

Ask us anything

56 reviews on our Google profile, copied word for word.

5.056 Google reviews(opens our Google profile in a new tab)
  • Makoto Taniguchi Google profile photoMakoto TaniguchiGoogle review · 6 months agoGoogle review
    Eddie was friendly, gave me a good quote, came in early and explained the tasks prior to starting and did an excellent job. Highly recommended.
  • Luiz Portella Google profile photoLuiz PortellaGoogle review · 7 months agoGoogle review
    Eddie is amazing! Great customer service and attention to details. He helped me with a leaky shower that needed a cartridge replacement and a couple of other minor repairs. 5 stars hands down. I recommend!
  • Talitha Nobrega Google profile photoTalitha NobregaGoogle review · 7 months agoGoogle review
    Second time using Encano Company, and Ed was amazing once again! He’s reliable, professional, and gets the job done quickly. Really appreciate the great service highly recommend!
  • BY K Google profile photoBY KGoogle review · 6 months agoGoogle review
    Really thankful to Ed for replacing our kitchen sink and garbage disposal. The service was fast,very professional and the quality of work was excellent. Highly recommend!
  • Onilton Maciel Google profile photoOnilton MacielLocal Guide · 3 months agoGoogle review
    Eddie is amazing. He is professional and quick in resolving the issues. He has very fair prices. Highly recommend!
  • gustavo de almeida frança Google profile photogustavo de almeida françaGoogle review · 3 months agoGoogle review
    Eddie is super friendly, helpful, and transparent! Always making sure his clients understand what needs to be done and how much it will cost ahead of time.
  • Pam Andrews Google profile photoPam AndrewsLocal Guide · 3 months agoGoogle review
    Great service. Eddie is knowledgeable and informative. Arrived very quickly and did an excellent job.
  • Larissa Rodrigues Google profile photoLarissa RodriguesGoogle review · 6 months agoGoogle review
    Eddie is very responsible! Best plumber in Vancouver area. I called him due to an emergency and he stopped by at the same day. I highly recommend him. 10/10

Boiler Repair questions

Straight answers. If yours is not here, text it to us.

Yes. Encano Plumbing takes no-heat and leaking boiler calls 24/7, including nights, weekends and holidays. Call or text (604) 764-2031 and describe what the boiler is doing. If there is any after-hours cost, we tell you before we come out, and the repair price is agreed upfront, in writing, before work starts.
A boiler that keeps losing pressure usually has a small leak somewhere in the loop, a pressure relief valve that is letting water out, or an expansion tank that has lost its air charge. Topping it up only hides the problem. A technician should find the cause, because running a boiler at low pressure can trigger lockouts and wear the pump.
Uneven heat is most often caused by air trapped in the system, a zone valve that is stuck closed, or a circulator pump that no longer moves enough water. In radiant floor systems, a single loop can also be air-bound. We test each zone, purge the air and repair the valve or pump that is holding back the flow.
Once a year is the usual recommendation, ideally in September or early October before the heating season starts. An annual service checks combustion and venting safety, pressure, the expansion tank, pumps and valves, and catches worn parts before they fail on a cold night. It also helps the boiler use gas efficiently.
It depends on the age of the boiler, the cost of the part and whether the heat exchanger is sound. Pumps, valves, igniters and controls are usually worth repairing. A cracked or badly leaking heat exchanger on an older unit often is not. We give you an honest repair price and tell you when replacement makes more sense.
Never ignore a CO alarm. Get everyone out of the home and call 911 from outside. If you also smell gas, call FortisBC’s 24-hour emergency line at 1-800-663-9911. Do not restart the boiler until it has been checked. We inspect venting, combustion and air supply and will not leave an unsafe appliance running.

Open now · 24 hours, 7 days

No heat at 2 a.m.? Call or text. We pick up.

Check the thermostat and the furnace or boiler power switch first, then call or text. The Encano team answers 24/7 and gives you the price before anyone touches a tool.

Call or text (604) 764-2031

Get your boiler repair price

Tell us what is going on. We reply with next steps and a time, and the price is agreed before any work starts.

Request an estimate

Tell us about your project and we will get back to you quickly. You know the price before we come out.

Photos (optional)

Photos help us quote faster. Up to 5.

We never share your info. The Encano team will get back to you soon.

Prefer to text?

Text us a photo of the problem

Snap a picture of the leak, drain or heater and send it to (604) 764-2031. Open 24/7.